Ring Size

If you do not know your ring size, it is best to have your finger sized by a professional jeweller. It would also be helpful to know the width of the sizer that has been used. 

Rings can also be made in ¼ and ½ sizes. If it is not possible to get to a jeweller, please email us at info@artifact.co.nz with your postal address and we can send you a free ring sizing card.

We can work with sizing systems from all countries ( A-Z, mm, inches, 1-15, US sizes etc.).

Inside ring shape

The most common ring profiles (outside and inside ring shapes) are pictured below. Other shapes may be available on request.

Titanium Grade

Most of our titanium rings are made from grade 4 pure titanium. Rings can also be made from grade 2 or aircraft grade 6Al4V titanium.All of our tension set rings are made from 6Al4V (aircraft grade) titanium.

Stones

Diamonds, rubies, sapphires can be set directly into titanium. Other stones need to be set into an inlay of a precious metal. Diamonds and sapphires are available in various colours. Please note that most rings with stones cannot be resized.

Finish

• Polished finish is a near mirror finish.
• Brushed finish has very fine brush marks around the ring.
• Satin finish is a fine sandblasted finish.
• Matt finish is a darker coarse sandblasted finish.
• Combination finish can be any combination of the different finishes. For this it may be necessary to have a fine dividing line or groove between the finishes.

Fonts

• We can engrave in the font styles (pictured below). Up to 40 characters including spaces can be engraved, depend on the ring's size and design.
• Other styles and sizes may be available on request.
• Inside ring engraving is free of charge.